- Frequently Asked Questions
- Which Grate material is best?
- Why is chain-link fencing the best material for security fences?
- What Type of Barbed Wire Fences Do You Need?
- Garden Fence Designs
- Decorative Garden Fencing Choices
- Accessories of wire mesh fencing
- More>>
- Technical Information
- Tips To Hot-dip galvanizing
- How to Install Fencing?
- Standard Specification for PVC Coated Chain Link Fence
- Wire Gauges of wire mesh
- The Features Of Chemistry Etching Products
- The Property Of Perforated Material
- More>>
- Screen Knowledge
- About the End Closures of the Cylinder Wire Mesh Filter
- Speaker grille
- Wire Cloth Glossary of Terms-3
- Wire Cloth Glossary of Terms
- Wire Cloth Glossary of Terms
- Knitted Wire Mesh
- More>>
- Payment Method
- T/T payment for small transaction on wire mesh
- Payment by L/C
- Payment methods
- More>>
Product Index: Home > Customer Service > Screen Knowledge > Screen Knowledge
About the End Closures of the Cylinder Wire Mesh Filter
Cap Solder - the end of the filter is dipped in molten solder, which fills the end opening. This is relatively inexpensive, but is limited to cylinders smaller than approximately 1/4 " in diameter.
Fishtail Weld - the end is pinched together and welded. This is usually the least costly method and is used when the width of the end closure may exceed the outside diameter of the cylinder.
Flush Bottom - a wire cloth cup is attached to the filter with the bottom surface flush with the end of the cylinder.
Folded End - the end of the cylinder is folded and secured. Usually used with finer meshes and low to moderate volume.
Inverted Bottom - a wire cloth cup is attached to the end of the filter with the bottom surface recessed into the end of the cylinder. This method is usually less expensive than a flush bottom.
Running Crease - same as fishtail weld, except that the width of the end closure is confined.
